https://www.selleckchem.com/products/sacituzumab-govitecan.html ICP-OES measurements were also carried out on samples taken from the reaction slurry. The composition of the precipitating solids at different reaction times was established by powder XRD and their morphology by SEM. Finally, were carried out to locate the additive after the completion of the precipitation reaction to get information about its potential reuse.Carbon nanotube (CNT)-reinforced nanocomposites represent a unique opportunity in terms of designing advanced materials with mechanical reinforcement and improvements in the electrical and thermal conductivities. However, the toxic effects of these composites on human health have been studied, and very soon, some regulations on CNTs and on composites based on CNTs will be enacted. That is why the release of CNTs during the nanocomposite lifecycle must be controlled. As the releasing depends on the interfacial strength that is stronger between CNTs and polymers compared to CNTs in a CNT agglomerate, two dispersion states-one poorly dispersed versus another well dispersed-are generated and finely described. So, the main aim of this study is to check if the CNT dispersion state has an influence on the CNT releasing potential in the nanocomposite. To well tailor and characterize the CNT dispersion state in the polymer matrix, electronic microscopies (SEM and TEM) and also rheological analysis are carried out to identify whether CNTs are isolated, in bundles, or in agglomerates. When the dispersion state is known and controlled, its influence on the polymerization kinetic and on mechanical properties is discussed. It appears clearly that in the case of a good dispersion state, strong interfaces are generated, linking the isolated nanotubes with the polymer, whereas the CNT cohesion in an agglomerate seems much more weak, and it does not provide any improvement to the polymer matrix. Raman spectroscopy is relevant to analyze the interfacial properties an