https://www.selleckchem.com/products/pki587.html Laser powder bed fusion (LPBF) is being increasingly used in the fabrication of complex-shaped structure parts with high precision. It is easy to form martensitic microstructure in Ti-6Al-4V alloy during manufacturing. Pre-heating the powder bed can enhance the thermal field produced by cyclic laser heating during LPBF, which can tailor the microstructure and further improve the mechanical properties. In the present study, all the Ti-6Al-4V alloy samples manufactured by LPBF at different powder bed temperatures exhibit a near-full densification state, with the densification ratio of above 99.4%. When the powder bed temperature is lower than 400 °C, the specimens are composed of a single α' martensite. As the temperature elevates to higher than 400 °C, the α and β phase precipitate at the α' martensite boundaries by the diffusion and redistribution of V element. In addition, the α/α' lath coarsening is presented with the increasing powder bed temperature. The specimens manufactured at the temperature lower than 400 °C exhibit high strength but bad ductility. Moreover, the ultimate tensile strength and yield strength reduce slightly, whereas the ductility is improved dramatically with the increasing temperature, when it is higher than 400 °C. Cystic fibrosis (CF) is one of the most common inherited diseases. It is characterised by a severe decline in pulmonary function associated with metabolic perturbations and an increased production of inflammatory cytokines. The key role of physical activity (PA) in improving the health status of CF patients and reducing lung function decline has recently been demonstrated. This study evaluated interleukin-6 (IL-6) and tumour necrosis factor α (TNFα) expression in two subgroups of CF patients classified based on PA. We selected 85 CF patients; half of them regularly undertook supervised PA in the three years leading up to the study and half of them were not physically active. Patien