PURPOSE Improved oral health of children is noted in most Western countries, but this coincides with a high burden of oral disease in several countries of Central and Eastern Europe. The purpose of the present study was to describe the current level of dental caries in Hungarian children aged 5, 6, and 12 years and to assess the long-term trends in caries over 30 years. In addition, the report aims to highlight the oral health habits of 12-year-old children in Hungary. MATERIALS AND METHODS A representative survey was undertaken in 2016-2017 according to the WHO Pathfinder methodology, which was also applied in previous national oral health surveys of 1985, 1991, 1996, 2001, and 2008. Children of 5-6 and 12 years were sampled systematically in all surveys over 30 years. Data were gathered through clinical examinations and a questionnaire used for 12-year-olds. RESULTS In 2016-2017, 42.6% of 5- to 6-year-olds were caries free, with the proportion lower in rural than urban settings. Approximately four primary tyear-olds by the year 2020. For better oral health of children, strong emphasis should be given to population-directed oral disease prevention, including the reduction of sugar consumption and implementing public health programmes for the effective use of fluoride.PURPOSE Periodontal disease is a chronic inflammatory disease characterised by the infiltration of inflammatory cells as well as activation of pathological angiogenesis in gingival tissues. Vascular endothelial growth factor (VEGF) plays a statistically significant role in the regulation of angiogenesis and induction of an inflammatory response in periodontal tissues. MATERIALS AND METHODS We examined the association between the VEGFA gene rs699947 polymorphism and periodontal disease. This study enrolled 200 patients with periodontal disease (130 non-smokers and 70 smokers) and 160 control subjects (126 non-smokers and 34 smokers). RESULTS There were no statistically significant differences in the distribution of VEGFA rs699947 genotypes and alleles between patients with periodontal disease and control subjects, also in the case when the analysis was performed in subgroups stratified according to smoking status. CONCLUSION The results of this study suggest there is no association between the VEGFA gene rs699947 polymorphism and periodontal disease.PURPOSE The aim of the present study was to analyse the role of the main diagnostic signs of poor periodontal status, probing depth (PD) ≥4 mm and bleeding on probing (BOP) ≥50%, both simultaneously and individually in preterm birth (PB) and their effect on the birth weight (BW). Prematurity is a major health concern and it is the leading contributing factor to neonatal morbidity and mortality worldwide. Conflicting results exist on the relation between poor maternal, periodontal status and adverse pregnancy outcome, including preterm deliveries and low birth weight (LBW).  https://www.selleckchem.com/  MATERIALS AND METHODS Seventy-seven PBs and 165 deliveries at term were analysed out of 242 patients. The perinatal factors such as gestational age (GA) and BW were analysed by BOP, categorised as ≥50% (high BOP) vs less then 50% (non-high BOP) and PD ≥4 mm vs less then 4 mm, in combination or separately. RESULTS The obtained results suggest that maternal periodontal inflammation, represented particularly by BOP, might be a triggering factor and can be associated with PB and LBW. For women with high BOP the adjusted odds ratio (AOR) for LBW was 2.28-fold and they were likely to have PB, with a 2.02-fold higher rate. CONCLUSION An increasing tendency of BOP seemed to be associated with a tendency to PB and LBW. Further investigations are necessary to underline this relationship, but the role of good oral health status in general, and particularly in case of pregnancy, is unequivocal.PURPOSE The air-particle-abrasion on zirconia in the gingival area of connectors and pontics in fixed partial dentures appears to increase fracture resistance. This study evaluated 'in situ' biofilm formation on the zirconia surface after different air-particle-abrasion protocols. MATERIALS AND METHODS Ninety sintered blocks (5 × 5 × 2 mm) of yttrium partially stabilised zirconia (Y-TZP) were obtained and randomised among nine groups according to the factors 'type of particle' (Alumina 50 and 110 µm; Cojet and Rocatec) and 'pressure' (2.5 and 3.5 bar) used for sandblasting for 10 s. The surface roughness (Ra/Rz) was measured before and after sandblasting. For the in-situ analyses, custom-made removable intraoral devices n = 10 with one sample of each group attached to the buccal area were used by volunteers for 8 h at night. The specimens were analysed under confocal microscopy to quantify both biovolume and thickness of the initial biofilm formed. One-way analysis of variance (ANOVA) and Dunnett's tests were performed (5%). RESULTS The roughness values ranged from 0.05 to 0.39 µm for Ra and from 0.35 to 2.11 µm for Rz, p = 0.00. Mean biofilm thickness ranged from 0.06 and 0.54 µm (p = 0.005), while the biovolume values were between 0.02 and 0.61 µm3/µm2 (p = 0.002). Values statistically significant for biofilm thickness and biovolume were found in groups sandblasted with Rocatec using 3.5 bar. CONCLUSION In order to increase the fracture resistance of zirconia fixed partial dentures (FPDs), the air particle abrasion of zirconia with SiO2 (110 μm/3.5 bar), in the gingival area of connectors and pontics, should be avoided.PURPOSE To evaluate the microtensile bond strength of dentine/self-adhesive resin cement interface after several treatments on a dentine surface. MATERIALS AND METHODS Twenty-eight human molars were selected and divided into four groups no treatment (control (C)); 2% chlorhexidine digluconate (CHX); 25% polyacrylic acid (PA); and 23 ppm dispersive solution of silver nanoparticle (SN). Prepolymerised TPH resin composite (Dentsply) blocks were luted on the dentine surface using RelyX U200 self-adhesive resin cement (3M ESPE). Microtensile bond strength was measured (MPa) in a universal testing machine 24 h and 6 months after the bonding process. The fractured specimens were examined in an optical microscope and classified according to the fracture pattern. A representative sample of each group was observed by scanning electronic microscope. Data were submitted to analysis of variance (ANOVA) and Tukey's test to compare the mean among the groups (p less then 0.05). RESULTS The highest microtensile bond strength values after 24 h were found for the PA group (13.