https://hiopmassage.com/ Regarding your assertion under, we highly counsel checking with Gigabyte support if X710-DA2 adapter is appropriate with X299 Designare EX as the validation would be based on the motherboard. As you will discover from the specs of the hyperlink we shared yesterday, Vertical Segment is for Server. I am on the lookout for a 10 Gb PCI Network Card for my Windows Workstation with two SFP+ Connectors to hook up with a synology by hyperlink aggregation. # Configure an IP handle and subnet maskfor Layer 3 aggregate interface Route-Aggregation 2. # Configure an IP handle and subnet maskfor Layer 3 aggregate interface Route-Aggregation 1. # Configure Layer 2 combination interfaceBridge-Aggregation 1 as an edge combination interface. MLAG ISSU (In-Service Software Upgrade) upgrades EOS software on one MLAG peer with minimal traffic disruptions on active MLAG interfaces and without altering the community topology. Link Aggregation is used most commonly to hyperlink high-bandwidth devices, such as servers, to the spine of a network. To reset the rate to the default worth of fast, run the nv set interface bond1 bond lacp-rate quick command. Cumulus Linux sets the bond configuration choices to the really helpful values by default; use caution when changing settings. The protocol is also identified as Dynamic Link Aggregation when a number of ports are connected to make a single high-bandwidth network. Dynamic-link aggregation supplies higher management over connections than static link aggregation. Within the IEEE specification the Link Aggregation Control Protocol (LACP) offers a technique to regulate the bundling of several bodily ports collectively to form a single logical channel. LACP permits a network gadget to negotiate an automated bundling of links by sending LACP packets to the peer (directly linked gadget that additionally implements LACP). LACP works by sending frames (LACPDUs) down all hyperlinks that have the protocol enabled. The first is t