The lesser grain borer, Rhyzopertha dominica, and the rust red flour beetle, Tribolium castaneum, are two major beetle pests commonly found infesting stored products worldwide. https://www.selleckchem.com/products/rp-6685.html Both species can cause severe economic damage and their management is complicated by their potential to develop resistance to several of the limited chemical options available. However, pest management strategies can be improved by understanding the ecology of the pest insect. To determine the spatiotemporal activity of R. dominica and T. castaneum, we conducted a trapping study over two years in a temperate region of south-eastern Australia, with traps located near grain storages and fields. We captured higher numbers of R. dominica than T. castaneum, and both species were more prevalent in traps located close to grain storages. Similar and consistent seasonal patterns were displayed by both species with activity ceasing during the winter (June-August) months. We found linear correlations between maximum daily temperatures and trap catches, and minimum threshold temperatures for flight activity were 14.5 °C and 15.6 °C for R. dominica and T. castaneum, respectively. The results are discussed in relation to the ecology of these pests along with their implications for pest management.Gene transcription has been uncovered to occur in sporadic bursts. However, due to technical difficulties in differentiating individual transcription initiation events, it remains debated as to whether the burst size, frequency, or both are subject to modulation by transcriptional activators. Here, to bypass technical constraints, we addressed this issue by introducing two independent theoretical methods including analytical research based on the classic two-model and information entropy research based on the architecture of transcription apparatus. Both methods connect the signaling mechanism of transcriptional bursting to the characteristics of transcriptional uncertainty (i.e., the differences in transcriptional levels of the same genes that are equally activated). By comparing the theoretical predictions with abundant experimental data collected from published papers, the results exclusively support frequency modulation. To further validate this conclusion, we showed that the data that appeared to support size modulation essentially supported frequency modulation taking into account the existence of burst clusters. This work provides a unified scheme that reconciles the debate on burst signaling.The receptor for advanced glycation end products (RAGE) contributes to many cellular aspects of pancreatic cancer including cell proliferation, migration, and survival. Studies have shown that RAGE activation by its ligands promotes pancreatic tumor growth by stimulating both cell proliferation and migration. In this study, we investigated the effect of RAGE up-regulation on the proliferation and migration of the human pancreatic cancer Panc-1 cell-line. We show that moderate overexpression of RAGE in Panc-1 cells results in increased cell proliferation, but decreased cell migration. The observed cellular changes were confirmed to be RAGE-specific and reversible by using RAGE-specific siRNAs and the small molecule RAGE inhibitor FPS-ZM1. At the molecular level, we show that RAGE up-regulation was associated with decreased activity of FAK, Akt, Erk1/2, and NF-κB signaling pathways and greatly reduced levels of α2 and β1 integrin expression, which is in agreement with the observed decreases in cell migration. We also demonstrate that RAGE up-regulation changes the expression of key molecular markers of epithelial-to-mesenchymal transition (EMT). Our results suggest that in the absence of stimulation by external ligands, RAGE up-regulation can differently modulate cell proliferation and migration in pancreatic cancer cells and regulates partly EMT.Poly(lactic acid) (PLA) nanocomposites were synthesized by a solution blending and coagulation method using alkylated graphene oxide (AGO) as a reinforcing agent. Turbiscan confirmed that the alkylation of GO led to enhanced compatibility between the matrix and the filler. The improved dispersity of the filler resulted in superior interfacial adhesion between the PLA chains and AGO basal plane, leading to enhanced mechanical and rheological properties compared to neat PLA. The tensile strength and elongation at break, i.e., ductility, increased by 38% and 42%, respectively, at the same filler content nanocomposite (PLA/AGO 1 wt %) compared to nonfiller PLA. Rheological analysis of the nanocomposites in the molten state of the samples was performed to understand the filler network formed inside the matrix. The storage modulus increased significantly from PLA/AGO 0.5 wt % (9.6 Pa) to PLA/AGO 1.0 wt % (908 Pa). This indicates a percolation threshold between the two filler contents. A steady shear test was performed to examine the melt flow characteristics of PLA/AGO nanocomposites at 170 °C, and the viscosity was predicted using the Carreau-Yasuda model.This work is focused on photocatalytic properties of titanium dioxide thin coatings modified with silver nanostructures (AgNSs) and graphene oxide (GO) sheets which were analyzed in processes of chemical transformations of rhodamine B (RhB) under ultraviolet (UV) or visible light (Vis) irradiation, respectively. UV-Vis spectroscopy was applied to analyze the changes in the RhB spectrum during photocatalytic processes, revealing decolorization of RhB solution under UV irradiation while the same process coexisting with the transformation of RhB to rhodamine 110 was observed under Vis irradiation. The novelty of this study is the elaboration of a methodology for determining the parameters characterizing the processes occurring under the Vis irradiation, which enables the comparison of photocatalysts' activity. For the first time, the method for quantification of rhodamine B transformation into rhodamine 110 in the presence of a semiconductor under visible light irradiation was proposed. Photocatalysts with various surface architectures were designed. TiO2 thin coatings were obtained by the sol-gel method. GO sheets were deposited on their surface using the dip-coating method. AgNSs were photogenerated on TiO2 or grown spontaneously on GO flakes. For characterization of obtained photocatalysts, scanning electron microscopy (SEM), X-ray diffraction (XRD) and diffuse-reflectance spectroscopy (DRS) techniques were applied. The results indicate that the surface architecture of prepared coatings does not affect the main reaction path but have an influence on the reaction rates and yields of observed processes.