Although superfine powdered activated carbon has excellent adsorption properties, it is not used in conventional water treatment processes comprising coagulation-flocculation, sedimentation, and sand filtration (CSF) due to concerns about its residual in treated water. Here, we examined the production and fate of very fine carbon particles with lacking in charge neutralization as a source of the residual in sand filtrate after CSF treatment. Almost all of the carbon particles in the water were charge-neutralized by coagulation treatment with rapid mixing, but a very small amount (≤0.4% of the initial concentration) of very fine carbon particles with a lesser degree of charge neutralization were left behind in coagulation process.  https://www.selleckchem.com/products/gyy4137.html  Such carbon particles, defined as stray carbon particles, were hardly removed by subsequent flocculation and sedimentation processes, and some of them remained in the sand filtrate. The concentration of residual carbon particles in the sand filtrate varied similarly with that of the entration after coagulation treatment and the residual carbon particle concentration in sand filtrate compared with a single-chambered reactor configuration. When a normal basicity PACl that consisted mainly of monomeric Al species was used, the stray carbon particle concentration was decreased during coagulation process and then gradually decreased during subsequent flocculation process because the monomeric Al species were transformed to colloidal Al species via polymeric Al species. In contrast, when a high-basicity PACl that consisted mostly of colloidal Al species was used, coagulation treatment largely decreased the stray carbon particle concentration, which did not decrease further during subsequent flocculation process. These findings will be valuable for controlling residual carbon particles after the CSF treatment.Due to the environmental risks caused by microplastics, understanding the sources and characteristics of microplastics and cutting off their routes into the environment are crucial. However, so far, studies on microplastics in the landfill leachate system (a major pathway of microplastics into the environment) are still limited, especially for tiny particles less then 50 µm that might have higher risks to the environment. This study investigated the microplastics in landfill leachate and in leachate treatment works, with a size detection limit down to 10 µm. The results showed that the microplastics particle and mass concentrations in the untreated leachate were 235.4 ± 17.1 item/L and 11.4 ± 0.8 µg/L, respectively, with tiny particles ( less then 50 µm) accounting for over 50%. Overall, 27 polymeric materials were detected in leachate samples, with polyethylene and polypropylene being the most abundant in the untreated leachate. The neutral buoyancy of microplastics (average density 0.94 g/cm3), together with irregular shapes, suggested they may be difficult to be removed by sedimentation. Further exploring the fate of microplastics in leachate treatment works showed that the membrane treatment effectively reduced microplastics loading to 0.14% for particle and 0.01% for mass, but the average particle density rose. The differences in polymeric materials distribution at different sampling locations and the presence of membrane-related polymer in membrane treatment effluent suggested tiny microplastics could be generated and released from membrane systems. Moreover, this study discovered that the sludge dewatering liquor could contain a high amount of microplastics, and the estimated particle loading was about 3.6 times higher than that in dewatered sludge. This suggested a new approach to microplastics mitigation through separating microplastics from the sludge dewatering liquor before its recirculation.Salt removal from seawater/wastewater using flow-electrode capacitive deionization (FCDI) is of particular interest, but scale-up desalination is limited by low water production, high energy consumption and complex cell configuration. In this study, an innovative FCDI system is described that uses integrated desalination modules equipped with membrane-current collector (MCC) assembly, and thereby named as MCC-FCDI system. A single desalination module design provides an average salt removal rate (ASRR, 0.3 - 0.44 µmol/(cm2·min)) close to that of the classic FCDI system (with a graphite current collector design), but the design requires a much lower infrastructure investment, device size and energy cost. More importantly, our design enables simultaneous operation of multiple modules in the shared flow-electrode tank, easily realizing scale-up desalination. Evidence is provided by the results of the multi-module operation multi-modules isolated closed-cycle (MICC) and multi-modules short-circuited closed-cycle (MSCC). For instance, the MICC configuration showing nearly twice the desalination performance over ~ 50 h of operation compared to that of the single ICC operation. The results indicated that in addition to making the device suitable for practical application, the Ti-mesh MCC with a woven network enables the flow electrode to achieve substantial ion adsorption capacity due to the efficient update of fresh carbon particles. In short, the results of this study showed that MCC-FCDI is a promising desalination system for scale-up applications, providing a new reference and guidance for device design.A one-year study was carried out in León, Spain, in order to characterize physically and chemically the precipitation. With the aim of studying the scavenging process of atmospheric pollutants, scavenging ratio and removal coefficients were calculated through physical parameters of raindrops (obtained by disdrometer data) and through chemical properties of aerosols. Finally, linear models for the prediction of the chemical composition of rainwater and the efficiency of the removal effect were established. In general, the rainwater was dominated by NH4+ > SO42- > NO3- in all seasons. Higher ion concentrations and conductivity and lowest pH were observed in summer, due to the low volume of rain. In winter, the high values of Na+ and Cl- in the rainwater showed the contribution from marine sources, while in summer the high concentrations of Ca2+, Mg2+, SO42-, NH4+ and NO3- reflected the contribution from both crustal and anthropogenic sources. The linear models revealed that the amount of dissolved organic carbon and of the water-soluble ions in rain samples, Ca2+, SO42-, NO3-, increases with the volume swept by the falling drops.