https://www.selleckchem.com/products/bleximenib-oxalate.html In this way, we can produce biodegradable NPs with a perfume loading up to 85 % w/w without the need for additional surfactants. Subsequently we show that the ionizable group is able to confer a positive charge to our nanoparticles and, in turn, a high adsorption capacity on natural fibers (i.e. hairs and cotton fabric). Finally, we demonstrate the nanoparticle resistance to rinsing and their ability to confer a long-lasting fragrance perception to treated hair swatches for at least 3 weeks. The emulsion stability depends on the physicochemical properties of the dispersed phase and their interaction with the continuous phase. Surface-active compounds (SAC) are added in emulsions to reduce the interfacial tension (IT) between these phases and keep the oil droplets stabilized. Moreover, small amounts of SAC can occupy intermolecular voids in the dried matrix, reducing the oxidation. However, the formulation must reflect a trade-off between protection and emulsion stabilization. Therefore, this work aimed to identify the minimum concentration of SAC (modified starch-MS, gelatin-GE, and whey protein isolate-WPI) ranging from 0.48 to 6 % (w/w) to form and stabilize droplets of an unsaturated triglyceride (fish oil-FO) or a volatile oil (orange essential oil-OEO). GE did not change the IT (6.7 mN/m) and stabilized the emulsions only through an increase of the viscosity (∼42 mPas for FO-emulsions and ∼97 mPas for OEO-emulsions), presenting high droplet size (∼10 μm) and low surface charge (∼1.5 mV). WPI reduced the IT to a limit value (4.5 mN/m at 1.2 % w/w for OEO and 5.3 mN/m at 2.4 % w/w for FO), whereas MS reduce constantly the IT with the increase of the concentration for both oils (∼4.2 mN/m at 6 % w/w). Both WPI and MS-emulsions presented similar droplet size (∼2.0 μm), but WPI presented higher surface charge of WPI-emulsions (-45 mV) than MS-emulsions (-30 mV). This study allowed to gain a consistent unde