https://www.openlearning.com/u/armstrongmcbride-soacsq/blog/FiveQualitiesThatPeopleSearchForInEveryImmobiliserGhost https://yamcode.com/10-facts-about-ghost-installer-that-will-instantly-put-you-in-a-good-m Ghost Immobiliser Fitting Protect your vehicle against key theft, cloning and hacking with the first aftermarket CAN-Immobiliser. The Ghost app and GPS tracking can be connected to the immobiliser to give you notifications when your vehicle is taken or damaged. Installing an Ghost immobiliser is relatively straightforward for the qualified technician. It is important to have the proper equipment and heat shrink tubing. Getting Started Unlike physical theft protection devices like wheel locks or car alarms, ghost immobilisers safeguard your vehicle without the need for key fobs or LED indicators. They are directly connected to the ECU CAN data network, and are activated only by entering a PIN code. This gives a greater level of protection against key hacking, ECU swapping and cloning. Installing a ghost immobiliser Birmingham requires a high degree of agility and accuracy. It's like tiptoeing through an icy minefield. One mistake could cause severe damage to the circuits of your vehicle's electrical system. It is important to understand the installation procedure and prepare your vehicle properly. It is necessary to remove interior panels from the vehicle in order to make room for the immobiliser. Once you have found the ideal place to hide it then use cable ties to ensure it is secured. Then, clean up the wiring by tying down loose wires and utilizing insulation tape or heat shrink tubing to cover the exposed connections. This reduces the chance of an accidental short circuit, while improving the aesthetics and reducing the chance of theft. Find a source of constant 12V power, and a grounding source for the ghost immobiliser. Once you've located them check the power cables with a multimeter. Connect and CAN L wires of the immobiliser with the grounding and power