https://www.selleckchem.com/products/sis17.html Self-sanction actions overcome the disadvantages of information-sharing actions, but consumers still require information on facts of and solutions to the crisis. Therefore, it is recommended that recalling firms combine these two strategies in the case of consumer trust repair in food recall crises. Furthermore, the involved firms are encouraged to employ a third party to release the scientific evidence.In this paper, we present a novel thermoresistive gas flow sensor with a high-yield and low-cost volume production by using front-side microfabricated technology. To best improve the thermal resistance, a micro-air-trench between the heater and the thermistors was opened to minimize the heat loss from the heater to the silicon substrate. Two types of gas flow sensors were designed with the optimal thermal-insulation configuration and fabricated by a single-wafer-based single-side process in (111) wafers, where the type A sensor has two thermistors while the type B sensor has four. Chip dimensions of both sensors are as small as 0.7 mm × 0.7 mm and the sensors achieve a short response time of 1.5 ms. Furthermore, without using any amplification, the normalized sensitivity of type A and type B sensors is 1.9 mV/(SLM)/mW and 3.9 mV/(SLM)/mW for nitrogen gas flow and the minimum detectable flow rate is estimated at about 0.53 and 0.26 standard cubic centimeter per minute (sccm), respectively.The paper proposes benchmark problems on exact solutions of hyper-elastic analysis, which can be used to evaluate analysis capabilities of rubber-like materials provided by a finite element program or other approximate solution methods. Special attention was concentrated on analysis and derivation of the exact solutions for the thick-walled rubber cylinders under internal pressure and axial extension, the thick-walled rubber balloons under internal pressure and the rubber cylinders under torsion or tension-torsion. Deformation and stres