https://www.selleckchem.com/products/sivelestat-sodium.html This work aims to investigate the process of obtaining highly filled glass and carbon fiber composites. Composites were manufactured using previously obtained cellulose derived polyol, polymeric methylene diphenyl diisocyanate (pMDI). As a catalyst, dibutyltin dilaurate 95% and Dabco® 33-LV were used. It was found that the addition of carbon and glass fibers into the polymer matrix causes an increase in the mechanical properties such as impact and flexural strength, Young's modulus, and hardness of the material. Moreover, the dynamic mechanical analysis (DMA) showed a significant increase in the material's storage modulus and rigidity in a wide range of temperatures. The increase in glass transition of soft segments can be noticed due to the limitation of macromolecules mobility in the material. The thermogravimetric analysis showed a four step decomposition, with maximal degradation rate at TmaxII = 320-330 °C and TmaxIII = 395-405 °C, as well as a significant improvement of thermal stability. Analysis of the material structure using a scanning electron microscope showed the presence of material defects such as voids, fiber pull-outs, and agglomerates of both fibers.Seasonal calving, pasture-based dairy systems are widely practiced in countries with a temperate climate and plentiful rainfall such as Ireland and New Zealand. This approach maximizes milk production from pasture and, consequently, is a low-cost, low-input dairy production system. On the other hand, the majority of global milk supply is derived from high input indoor total mixed ration systems where seasonal calving is not practiced due to the dependence on ensiled silages, grains and concentrated feeds, which are available year-round. Synchronous changes in the macro and micronutrients in milk are much more noticeable as lactation progresses through early, mid and late stages in seasonal systems compared to non-seasonal systems-which can have