https://www.selleckchem.com/products/hro761.html Concrete has become the most common construction material, showing, among other advantages, good behaviour when subjected to high temperatures. Nevertheless, concrete is usually reinforced with elements of other materials such as steel in the form of rebars or fibres. Thus, the behaviour under high temperatures of these other materials can be critical for structural elements. In addition, concrete spalling occurs when concrete is subjected to high temperature due to internal pressures. Micro polypropylene fibres (PP) have shown to be effective for reducing such spalling, although this type of fibres barely improves any of the mechanical properties of the element. Hence, a combination of PP with steel rebars or fibres can be effective for the structural design of elements exposed to high temperatures. New polyolefin fibres (PF) have become an alternative to steel fibres. PF meet the requirements of the standards to consider the contributions of the fibres in the structural design. However, there is a lack of evidence about the behaviour of PF and elements made of polyolefin fibre reinforced concrete (PFRC) subjected to high temperatures. Given that these polymer fibres would be melt above 250 °C, the behaviour in the intermediate temperatures was assessed in this study. Uni-axial tests on individual fibres and three-point bending tests of PFRC specimens were performed. The results have shown that the residual load-bearing capacity of the material is gradually lost up to 200 °C, though the PFRC showed structural performance up to 185 °C.Clinical evidence regarding risk reduction of repeated bladder recurrence after initial photodynamic diagnosis (PDD)-assisted transurethral resection of bladder tumor (TURBT) is still limited in patients with non-muscle-invasive bladder cancer (NMIBC). We analyzed patients with primary NMIBC undergoing TURBT without any adjuvant treatment to compare the risk of cumulative recurrence betw