https://www.selleckchem.com/products/brefeldin-a.html The magnetic field (MF) induced alignment of cellulose nanocrystals (CNC) within a starch matrix is investigated and its effect on the physicochemical and mechanical properties of the nanocomposites are discussed in the paper. Two different kinds of CNC i.e. plant-CNC and tunicate-CNC and its hybrid combination are studied to understand the effect of aspect ratio of CNC on the properties of nanocomposite. Nanocomposites with tunicate sourced CNC showed higher tensile strength and modulus, and lower water vapor permeability as compared to plant sourced CNC. These properties are higher for nanocomposites prepared under MF. The modulus of starch nanocomposites increased from 0.26 GPa and 0.32 GPa to 0.38 GPa and 0.44 GPa, respectively for plant-CNC and tunicate-CNC when exposed to MF. The improved orientation and alignment of CNC in presence of MF is further supported by Raman and scanning electron micrographs studies.Simultaneous stiffening, strengthening, and toughening of biodegradable polymers, such as poly(butylene adipate-co-terephthalate) (PBAT) and others, is necessary for their use in packaging and agriculture applications. However, a high content of nanoinclusions is usually required, leading to a tradeoff between composite toughness and strength or stiffness in the reinforcement. Herein, we report an iterative reinforcement strategy that uses one nanocomposite to reinforce PBAT. An in-situ grafting polymerized cellulose nanocrystal (CNC)/PBAT (CNC-g-PBAT) nanocomposite consisting of ungrafted/free PBAT (PBATf) was used as an inclusion directly to reinforce a commercial PBAT. At an exceptionally low CNC usage of 0.02 wt.%, we achieved a simultaneous enhancement of the Young's modulus by 26 %, tensile strength by 27 %, elongation at break by 37 %, and toughness by 56 % over those for PBAT. To the best of our knowledge, such reinforcement efficiency is the highest among similar biodegradable polymer nanocomp