https://telegra.ph/Your-Family-Will-Thank-You-For-Getting-This-Ghost-Immobiliser-12-12 Ghost Immobiliser Fitting Guard your car from key theft hacking, cloning and theft by using the world's first aftermarket immobiliser for CAN. The Ghost app and GPS tracking can be connected to the immobiliser, which will send you notifications when your vehicle is taken or damaged. The installation of an Ghost immobiliser is done by a trained technician. The right tools, insulation tape, and heat shrink tubing is essential. Getting Started Unlike physical theft protection devices like wheel locks and car alarms, ghost immobilisers guard your vehicle without the need for LED indications or key fobs. Instead they connect directly to the ECU's CAN network and can only be started after entering a PIN sequence. This gives a more secure level of protection from key hacking, cloning and even ECU swapping. Installing a ghost immobiliser Birmingham requires a high level of agility and precision. It can be a bit like tiptoeing through a minefield; one misstep can cause serious damage to the circuits of the electrical system of your vehicle. It is essential to comprehend the procedure for installing and prepare your vehicle correctly. You'll need to take out interior panels from the vehicle to make room for the immobiliser. Once you've found the ideal place to conceal it and secure it with cable ties to keep it from being removed or tampered with. Then, tidy your wiring by making sure that loose wires are tied down and using insulation tape to cover the exposed connections. This reduces the chance of a short circuit that is not intended to happen and improve the appearance and reducing the risk of theft. Find a source of constant 12V power and a grounding point for the ghost immobiliser. Once you have located them check the power cables with a multimeter. Connect the CAN H and the CAN L wires of your immobiliser with the power source and grounding points. Once you've made all of the connect