https://www.selleckchem.com/products/DMXAA(ASA404).html Self-assembly at the air/water interface (AWI) has proven to be an efficient strategy for fabricating two-dimensional (2D) colloidal monolayers, which was widely used as the template for nanosphere lithography in nanophononics, optofluidics, and solar cell studies. However, the monolayers fabricated at the AWI usually suffer from a small domain area and quasi-double layer structure caused by submerged particles. To overcome this, we proposed an improved protocol to prepare 2D colloidal monolayers free of overlapping nanospheres at the AWI. Utilizing the stable suspension infusion to the water surface, a convex meniscus, whose height is related to viscous force, was formed adjoining the three-phase boundary. As a result of the resistance of the convex meniscus, the polystyrene nanospheres in the initial suspension directly self-assembled into a preliminary monolayer, which proved effective in preventing nanospheres' sinking and increasing the colloidal crystal domain size. An optimal parameter for transferring the monolayer was also developed based on the numerical simulation results. Finally, a wafer-scale monolayer, covered with less than one nanosphere per 100 μm × 100 μm area, was achieved on the desired substrate with an average domain size attaining centimeter scale. The high-quality 2D colloidal crystal may further promote the application of nanosphere lithography, especially in the fields that require a defect-free template.The impact of the chain length or dispersity of polymers in controlling the crystallization of amorphous active pharmaceutical ingredients (APIs) has been discussed for a long time. However, because of the weak control of these parameters in the majority of macromolecules used in pharmaceutical formulations, the abovementioned topic is poorly understood. Herein, four acetylated oligosaccharides, maltose (acMAL), raffinose (acRAF), stachyose (acSTA), and α-cyclodextrin (ac-α-CD) of gro