The surface morphology clearly stated the loading of CuO QDs loaded HA/PLGA microspheres. The capping of the polymer matrix was also studied using FTIR analysis. A Photoluminescence spectrum is also recorded. This study was illustrating that Piperine loaded CuQDs@HA/PLGA nanostructures exhibit improved neuroprotection and encourage the activation of astrocytes in chemical kindling model of epilepsy. This proposed material could be a novel and effective therapeutic platform for the targeted drug delivery systems. Mesoporous silica@nano-zinc amino-tris-(methylenephosphonate) (m-SiO2@Zn-AMP) spheres were synthesized via a self-assembly process to integrate the outstanding flame retardancy, thermal stability, and mechanical properties of these materials. The results indicated that nano Zn-AMP particles were successfully deposited on the surface of m-SiO2 through electrostatic interactions. The prepared m-SiO2@Zn-AMP was utilized to improve the flame retardancy, smoke suppression, and mechanical properties of epoxy resin (EP). The storage modulus, impact, and tensile strengths of the EP with 1% m-SiO2@Zn-AMP (sample EP/1m-SiO2@Zn-AMP) were increased by 29.9, 50.0, and 23.5 %, respectively, relative to the values for untreated EP. The presence of multiple flame retardant elements (i.e. Si, P, N, and Zn) in the mesoporous spheres led to the formation of high yields of compact char residues and the release of inert substance during combustion, for high flame retardancy and efficient smoke suppression in the condensed and gaseous phase. The EP/5m-SiO2@Zn-AMP sample achieved a V0 rating in a vertical UL-94 test. Compared to untreated EP, the amount of total smoke released and the peak CO production rate of EP/5m-SiO2@Zn-AMP were reduced by 53.1 and 61.5 %, respectively. Additionally, the total heat release and peak heat release rate of EP/5m-SiO2@Zn-AMP were decreased by 45.2 and 57.8 %, respectively. Metal mixture toxicity across soil types is a daunting challenge to risk assessment. Here, we evaluated metal mixture toxicity in Oppia nitens, using ten fixed metal mixture ratios in five Canadian soils that closely matched some of the EU PNEC reference soils. Soils were dosed with five metals (Cu, Zn, Pb, Co, Ni) as single metals (ten concentrations) and as mixtures (eight concentrations). Synchronized adult mites were exposed to metals, with survival and reproduction assessed after 28 days. We found out that (i) the differences among soils in mite sensitivity and single metals were not consistent when mites were exposed to metal mixtures, (ii) assuming concentration addition, the mixture interaction factor (MIF) showed that single metal low effect levels excessively underestimated low level metal mixture effects (iii) Zn emerged as a protective metal in most mixtures, and (iv) Soil properties such as CEC, independent of effects on metal speciation, explained more of the variation than measured metals. This study suggests that metal risk assessment should be done on a case by case basis. Further work is needed to ensure that by protecting soil-dwelling organisms from single metals, the risk from metal mixtures is appropriately protected for. Stormwater conveys natural and engineered (nano)-particles, like any other pollutants, from urban areas to water resources. Thus, the use of stormwater green infrastructures (SGI), which infiltrate and treat stormwater, can potentially limit the spread of engineered (nano)-particles in the environment. However, the concentration of engineered (nano)-particles in soil or biofilter media used in SGI has not been measured due to difficulties in distinguishing natural vs. engineered (nano)-particles. This study reports, for the first time, the concentration and size distribution of TiO2 engineered (nano)-particles in soils collected from SGI. The concentrations of TiO2 engineered (nano)-particles were determined by mass balance calculations based on shifts in elemental concentration ratios, i.e., Ti to Nb, Ti to Ta, and Ti to Al in SGI soils relative to natural background elemental ratios. The concentrations of TiO2 engineered (nano)-particles in SGI soils varied between 550 ± 13 and 1800 ± 200 mg kg-1. A small fraction of TiO2 engineered (nano)-particles could be extracted by ultrapure water (UPW) and Na4P2O7; however, the concentration of TiO2 engineered (nano)-particles was higher in the Na4P2O7-extracted suspensions than in UPW-extracted suspensions. The concentration of TiO2 in the nanosize range increased with the increase in extractant (Na4P2O7) volume to soil mass ratio due to the increased disaggregation of soil heteroaggregates. The size distribution of TiO2 engineered (nano)-particles in the less then 450 nm Na4P2O7-extracted suspension from one of the SGI soils was determined by asymmetrical flow-field flow fractionation coupled to inductively coupled plasma-mass spectrometer, and was found to vary in the range of 25-200 nm with a modal size of 50 nm. These results demonstrated that the increase in the Ti to natural tracers (e.g., Nb, Ta, and Al) elemental ratios in the SGI soil relative to bulk soil can be used to estimate the concentration of TiO2 engineered (nano)-particles in SGI. Composted livestock and poultry manure, which may contain antibiotic resistance genes (ARGs), is widely used as natural fertilizer in China. But the influence of soil types on ARGs is not well characterized, particularly at greenhouse sites with long-term manure application. We investigated the distribution of ARGs in the cinnamon, fluvo-aquic and saline-alkali soils in greenhouse of Yellow River Delta region, China.  https://www.selleckchem.com/products/Temsirolimus.html  A total of 193 ARGs subtypes were detected, with multidrug and aminoglycoside resistance genes as the most universal ARGs subtypes. Soil types influenced the ARGs distribution, where higher levels of diversity and relative abundance of ARGs in the fluvo-aquic and saline-alkali soils compared with those in the cinnamon soils. Among abiotic factors, sand, pH and Zn contributed more to the pattern of ARGs in the cinnamon soils, whereas sand and Cd, clay and Pb contributed the most in the fluvo-aquic and saline-alkali soils respectively. Furthermore, positive correlations between the relative abundances of ARGs and mobile genetic elements (MGEs) in the fluvo-aquic soils, suggesting higher dissemination potential of ARGs in this type of soil.