The gradual decrease in the film thickness, upon immersion of the coatings in mildly basic (pH 8), neutral (pH 7), and acidic (pH 6) media, reaching 10, 20, and 70% reduction, respectively, after 60 days of immersion time, confirmed the polishing behavior of the films, whereas their effective antimicrobial action was retained. The biocompatibility of the hybrid films was verified in human cell culture studies. The proposed approach enables the facile development of highly functional coatings, combining biocompatibility and bactericidal action with a "kill and self-clean" mechanism that allows the regeneration of the outer surface of the coating leading to a strong and prolonged antimicrobial action.The rational construction of advanced sensing platforms to sensitively detect H2O2 produced by living cells is one of the challenges in both physiological and pathological fields. Owing to the extraordinary catalytic performances and similar metal coordination to natural metalloenzymes, single atomic site catalysts (SASCs) with intrinsic peroxidase (POD)-like activity have shown great promise for H2O2 detection. However, there still exists an obvious gap between them and natural enzymes because of the great challenge in rationally modulating the electronic and geometrical structures of central atoms. Note that the deliberate modulation of the metal-support interaction may give rise to the promising catalytic activity. In this work, an extremely sensitive electrochemical H2O2 biosensor based on single atomic Fe sites coupled with carbon-encapsulated Fe3C crystals (Fe3C@C/Fe-N-C) is proposed. Compared with the conventional Fe SASCs (Fe-N-C), Fe3C@C/Fe-N-C exhibits superior POD-like activity and electrochemical H2O2 sensing performance with a high sensitivity of 1225 μA/mM·cm2, fast response within 2 s, and a low detection limit of 0.26 μM. Significantly, sensitive monitoring of H2O2 released from living cells is also achieved. Moreover, the density functional theory calculations reveal that the incorporated Fe3C nanocrystals donate electrons to single atomic Fe sites, endowing them with improved activation ability of H2O2 and further enhancing the overall activity. This work provides a new design of synergistically enhanced single atomic sites for electrochemical sensing applications.Surface defects of perovskite films are the major sources of nonradiative recombination which limit the efficiency and stability of perovskite solar cells. Surface passivation represents one of the most efficient strategies to solve this problem. Herein, for the first time we designed a porphyrin-involved benzene-1,3,5-tricarboxamide dendrimer (Por-BTA) as a multifunctional interface material between the interface of the perovskite and the hole-transporting layer (spiro-OMeTAD) for the surface passivation of perovskite films. The results suggested that Por-BTA not only efficiently passivated the perovskite surface defects via the coordination of the exposed Pb2+ with the carbonyl unit and basic sites of pyrrole units in Por-BTA but also improved the interface contact and the charge transfer between the perovskite and spiro-OMeTAD ascribed to the strong intermolecular π-π stacking of Por-BTA. It was shown that the PSC devices with the Por-BTA treatment exhibited improved power conversion efficiency with the champion of 22.30% achieved (21.30% for the control devices), which is mainly attributed to the increased short-circuit current density and fill factor. Interestingly, the stability of moisture for the Por-BTA-treated device was also enhanced compared to those without the Por-BTA treatment. This work presents a promising direction toward the design of multifunctional organic molecules as the interface materials to improve the cell performance of PSCs.When a droplet lands over a nonwetting surface it forms a convex interface that makes a contact angle larger than 90°.  https://www.selleckchem.com/products/arv-110.html  If the droplet lands over a pore opening, an interface is also formed at the pore opening that can prevent the droplet from permeating. The conditions for permeation and pinning are very much related to a threshold critical pressure that above which the droplet will permeate. This property defines a selectivity criterion for microfiltration processes of oily water systems using membrane technology. Such a feature of the membrane gets compromised, however, due to the permeation of droplets that are relatively smaller in size or whose critical entry pressure is smaller than the applied transmembrane pressure (TMP). In this work, we investigate what happens to a droplet when it coalesces with a droplet that undergoes permeation. Two scenarios are considered namely, (1) a droplet coalesces with a permeating one whose interface inside the pore has not broken through the pore exit and (2) a droplet coalesces with a permeating one whose interface in the pore has broken through. We show that a larger droplet (that will essentially not permeate if pinned over a membrane opening) will now permeate when the pore is filled with oil from a preceding one or recoils when the interface inside the pore of a preceding droplet has not broken through the exit of the pore. This has interesting implications for the rejection capacity of the membrane, which decreases due to the permeation of droplets that would, otherwise, not permeate. A computational fluid dynamic (CFD) study has been conducted to confirm the conclusions obtained from the theoretical study and to reproduce the fates of the combined droplet after coalescence at the surface of the membrane. Furthermore, a simplified formula for estimating the critical entry pressure is developed.Mussel-inspired surface modification has received significant interest in recent years because of its simplicity and versatility. The deposition systems are still mainly limited to molecules with catechol chemical structures. In this paper, we report a novel deposition system based on a monophenol, vanillic acid (4-hydroxy-3-methoxybenzoic acid), to fabricate metal-phenolic network coatings on various substrates. The results of the water contact angle and zeta potential reveal that the modified polypropylene microfiltration membrane is underwater superhydrophobic and positively charged, showing applications in oil/water separation and dye removal. Furthermore, the single-face modified Janus membrane is promising in switchable oil/water separation. The results demonstrate a novel example of the metal-monophenolic deposition system, which expands the toolbox of surface coatings and facilitates the understanding of the deposition of phenols.