Inexpensive and sustainable methods are needed to reclaim nutrients from agricultural waste solutions for use as a fertilizer while decreasing nutrient runoff. Fe(III)-polysaccharide hydrogels are able to flocculate solids and absorb nutrients in liquid animal waste from Confined Animal Feeding Operations (CAFOs). Fe(III)-alginate beads absorbed 0.05 mg g-1 NH4+ and NO3- from 100 ppm solutions at pH = 7, with > 80% phosphate uptake and ∼30% uptake of ammonium and nitrate. Ammonium uptake from a raw manure solution (1420 ppm NH4+) showed a significant 0.7 mg g-1 uptake. Tomato plant trials carried out with Fe(III)-alginate hydrogel beads in greenhouse conditions showed controlled nutrient delivery for the plants compared to fertilizer solution with the same nutrient content. Plants showed an uptake of Fe from the gel beads, and Fe(III)-alginate hydrogel beads promoted root growth of the plants. The plants treated with nutrient-loaded Fe(III)-alginate hydrogels yielded comparable tomato harvest to plants treated with the conventional fertilizer solution.To study the effect of CO2 on the explosion characteristics of CH4/CO, the explosion experiments of the effect of different volume fractions of CO2 on CH4/CO deflagration were carried out by using the self-developed pipeline gas explosion experimental platform. The explosion characteristics of premixed gas are studied from the aspects of explosion peak pressure and time of reaching the peak pressure.  https://www.selleckchem.com/products/Staurosporine.html  The results show that the effect of CO on the deflagration of methane with a different volume fraction is the result of the interaction of the elementary reaction and the oxygen content in the reaction system. Two percent of the CO promoted the methane explosion in the oxygen-rich state, while it showed a damping effect in the oxygen-poor state. CO2 has different inhibitory effects on different volume fractions of methane. Experiments show that the addition of 20% CO2 can effectively inhibit the deflagration of methane. The addition of CO2 has a stronger inhibitory effect on the mixed gas of CH4/CO under the condition of poor oxygen but less on the mixed gas under the condition of rich oxygen.In the present study, pore adsorption behavior of globular myoglobin (Mb) at mesoporous silicas was examined utilizing the low-temperature differential scanning calorimetry (DSC) method. The DSC method relies on a decrease in heat of fusion for the pore water upon adsorption of Mb. The amount and structure of Mb adsorbed into the mesoporous silica were examined by DSC and optical absorption spectroscopy. The results indicated that the pore adsorption behavior of Mb strongly depended on the solution pH and pore size of mesoporous silica. For the adsorption of Mb (diameter = 3.5 nm) into mesoporous silica with narrow pores (pore diameter = 3.3 nm) at a pH ranging from 7.0 to 3.7, the penetration of both folded and denatured Mb molecules was confirmed. The folded Mb could penetrate into large mesoporous silica pores (pore diameter = 5.3 and 7.9 nm), whereas the penetration of the denatured Mb molecules was completely inhibited. The distribution of folded Mb at mesoporous silica depended on the pore size; almost all folded Mb molecules located inside mesoporous silica pores of diameters 3.3 and 5.3 nm, whereas the Mb molecules distributed at bot internal and external pore surfaces of mesoporous silica with 7.9 nm in pore diameter. These pore adsorption behaviors suggest that aggregation or stacking of the Mb molecules at the pore entrance regions of the large pores affected the pore adsorption behavior.In this study, silver-strontium-doped hydroxyapatite (AgSr-HA)/chitosan composite coatings were deposited on a 316L stainless steel (SS) substrate via electrophoretic deposition (EPD). The Taguchi design of experiment (DoE) approach was used to optimize the EPD parameters such as the applied voltage, interelectrode spacing, and deposition time. Furthermore, the concentration of AgSr-HA particles in the suspension was also optimized via the DoE approach. DoE results demonstrated that the "homogeneous" coatings were obtained at the deposition time of 7 min, deposition voltage of 20 V, and at a concentration of 5 g/L AgSr-HA particles in the suspension. Scanning electron microscopy (SEM), energy-dispersive X-ray spectroscopy (EDS), antibacterial studies, contact angle, and roughness measurements were performed to characterize the optimized coatings. SEM images confirmed the deposition of chitosan/AgSr-HA on the SS substrate. The wettability studies indicated the hydrophilic nature of the chitosan/AgSr-HA composite coatings, which confirmed that the developed coatings are suitable for biomedical applications, e.g., orthopedics. The average surface roughness of the chitosan/AgSr-HA composite coatings was in a suitable range used to attach the bone marrow stromal cells. Chitosan/AgSr-HA composite coatings showed an effective antibacterial effect against Gram-positive and Gram-negative bacteria. Moreover, the coatings developed apatite crystals on their surface upon immersion in simulated body fluid.Synthesis and characterization of substituted 2,6-dibenzylidene cyclohexanone-based bischalcone derivatives and their optimized geometries were investigated by density functional theory. The synthesized compounds were identified through ultraviolet-visible, Fourier transform infrared, and 1H nuclear magnetic resonance spectroscopies and elemental analysis. Significant acidochromic behavior was observed for 2,6-bis(4-dimethylamino-benzylidene)-cyclohexanone 1e. This result is owing to the preferential protonation of the chromophoric N,N-dimethylamino group, that is, quaternary salt formation and deactivation of the resonance system. The result was consistent with computational studies where the protonation was favored by 211 kcal/mol in the gas phase. The compounds also showed solvatochromic behavior. The geometries of the synthesized compounds were optimized with B3LYP/6-311G+(d,p) and APFD/6-311+G(d,p) basis sets. The single point energy indicated that APFD/6-311+G(d,p) basis set gave the lowest energy of 445-655 kcal/mol for the studied bischalcone derivatives. Quantum chemical parameters were also calculated.